Topic: 2014 BMW CAS4 key programming using XTOOL X100 PAD3 via OBD.
What you need:
Car: 2014 BMW CAS4
Keys: one (original) working key+ one new (blank) key
Device: XTOOL X100 PAD Elite auto key programmer
Test two car keys:
Step-by-step guide to match the key via OBD:
Connect X100 PAD3 with the vehicle via main cable and OBDII-16 adapter
Open X100 PAD Elite tablet to operate
Click on [Diagnosis]
Select [BMW], agree with the disclaimer
Select [Match Key]
Then it will prompt that “Need to connect the network to complete this function, please confirm that the network connection is normal.” Just press “YES”
Then turn on the ignition switch and hazard warning lights
Connect to the Internet
Open Wifi setting option to select the corresponding wifi to match
Enter WiFi password, then press “Connect”
Press Back icon
Then click “OK”, you will see vehicle info displayed on the screen
Click “OK” to continue
You will see keys info 1-10 displayed here
The key pos 1-2 are used, and the key pos 3-10 are unused
Choose one unused key pos and press [Keys matching]
Confirm the key pos selected, click “YES”
Select [Requires original car key to operate]
Follow the instructions on the screen to operate
Keep the original car key close to the sensing area
Put the new key at the car induction coil
Checking the new key…
Reading key data…
X100 PAD3 tablet program new key successfully
In the key info you can see the key pos is used now
Check back icon
The screen shows key programming finished
Finally, test the keys to see if they work normally
Fyi…
New XTOOL KC501 car key programmer works with X100 PAD Elite can support the same function as Xhorse VVDI2, such as read and write keys, MCU/EEPROM chips, generate key, etc.
Read also: