After replacing the front windshield of the car, some car owners may find a malfunction that becomes the incomplete aim of the B2A60-54 static camera. Now you can easily solve this problem with Launch X431 PAD V and X431 ADAS PRO.
Vehicle and devices used:
Car model: Honda Civic Type R (2017)
Launch X431 PAD V (X431 PAD 5)
Launch X431 ADAS PRO
Case: Start the car, and the warning lights appear on the dashboard.
Guide to solve B2A60-54 Static Camera Aiming Incomplete fault:
Make sure the connection between launch devices and vehicle is proper
Start to operate on X431 PAD V tablet
1.Perform full diagnosis
Select Local Diagnose-> Asian-> HONDA-> 16 PIN DLC-> General
(Connect the VCI in WiFi mode)
Read out the vehicle info
Go to System and Function-> System Topology
The B2A60- 54 fault code can be found in the System List
Select ADAS Calibration-> ADAS System Scan
Click “Start scanning”
You can see there is a DTC (B2A60- 54) appears on LDW/ACC Integrated Driver Support system (IDAS)
Tap “ENTER”
Record or print the ECU ID info read out
2.Read fault code
Select “Read Fault Code”-> Confirm the module info incl. VIN, ECU name/identifier/ SN-> Read out fault code
3.Calibrate IDAS
Select “Special Function”
When executing the following functions, PHEV, FHEV and RLX Hybrid vehicles must be put into maintenance mode for the engine to run. Refer to the service manual for detailed instructions.
Select “Static Camera Aiming” and select the ADAS Calibration equipment (ADAS Pro)
Read the on-screen instructions of calibration required and pre-calibration preparation
Setup the ADAS Pro with the distance
Start the calibration and wait for the static camera aiming is complete
Turn the ignition switch off and then turn on
Confirm to save the ADAS report- The calibration result shows success
After that, read fault code again
Now there is no trouble code in the Integrated Driver Support System (IDAS), the fault B2A60-54 Static Camera Aiming Incomplete is cleared successfully.
Finally, full diagnose to check all systems working normally, and all warnings are also gone.
Launch X431 PAD V with Smartbox 3.0 Diagnostic Coding and Programming Tool (One Year Free Update) is available in eobdtool.co.uk.
https://www.eobdtool.co.uk/wholesale/launch-x-431-pad-v.html