X431 PAD 7 Diagnostic Tool designed for module increase, so you can add the modules to the device to increase your diagnostic capabilities.
Here we're going to share the unboxing and Optional Modules Intro.
Pad VII Tablet
13.3-inch touch screen with Gorilla glass.
A carry handles
A handle area at the back (that can be hooked onto the bonnet when you are doing the diagnosis inside the vehicle engine bay)
An adjustable handle (by which the device can be held on the steering wheel or on bench)
3 buttons(Power, Volume+, Volume-)
Two built-in cameras(one at the front, one at the back)
A built-in LED(as a light or camera flash)
Smart Link C (VCI)
All-in-one VCI with LCD screen for passenger & commercial vehicles.
If the software has been purchased, it’s able to do the pass-through programming.
O2-1 Scope Box(optional)
The four-channel scope can be added to the tablet via a USB port.
Allow us to do the scoping if you’re required to do it at the back or the front of the vehicle.
With Pad VII, we can do this scope on the screen and see the wave patterns in the signals.
S2-1 Sensor Box(optional)
The sensor simulator & multimeter can also be hooked to the tablet.
Allow us to generate signals and emulate the sensor to the SU, and read the voltage and ohms.
If you are in tight areas, and you are required to have a camera available and take photos, we also have the unit that is capable of plugging into it.
BST-360 Bluetooth Battery Tester(optional)
It’s as simple as connecting the red to the positive and the black to the negative, and linking the tablet up, and then you can do a complete battery test and also an alternator ripple test.
X-PROG 3 Immobilizer Programmer(optional)
This gives us the capability of cloning ECUs and programming keys where the security system is required to access.
More functions to be explored!