The VAPON VP100 BMW Key Programmer is compatible with original BMW OEM remotes for adding new keys to BMW G chassis vehicles equipped with the BDC2 module. No annual subscription fee is required.
Before generating a dealer key, you must use the VP100 BDC Adapter to connect to the BDC module for pre-processing. Carefully follow the wiring diagram and tutorial shown in the figures below to ensure proper connection between the BDC Adapter and the BDC module.
VAPON VP100 BDC Adapter is in the VP100 Key Programmer package by default
Wiring diagrams:
Solder the chip marked in the figure to pin 2, connect the EPP2 GND of the adapter
Here is the back side, number 5 from left to right, and then solder it to the wire which connects to the boot line on the BDC Adapter
Complete connection diagram:
Simple guide to add key to BMW G chassis BDC2 module by VP100:
1.Connect VAPON VP100 to the vehicle for BDC code backup via OBD
2.Remove the BDC2 module from the vehicle and use the VP100 BDC Adapter to perform pre-processing (see the above wiring diagram and wiring tutorial)
3.After the pre-processing is completed, install the BDC2 module back to the vehicle to generate the dealer key
4.Place the generated dealer key close to the key induction coil (usually on the right side of the steering column)
Press and hold the start button for 20 seconds
After the matching is successful, check whether the key is working properly
Learn more:
http://blog.eobdtool.co.uk/how-to-add-key-to-bmw-g-chassis-bdc2-2015-2021-by-vapon-vp100/
UK Professional OBD2 Tools Online Shop